Workgroup Remote Access Switch 173CONFIGURING D EVICE L EVEL DATABASESOn-node Device EntriesBridging with PPP Bridge Devices (Using BCP)To allow a PPP Bridge device to connect to the CyberSWITCH, you must have Bridging enabled.For each PPP Bridge device using this type of connection, you may need to enter a PAP Passwordor a CHAP Secret, and a Calling Line Id.The following table identifies the configuration requirements for possible security options for PPPBridge Devices.Note: If CHAP Security is enabled, and Outbound Authentication has not been disabled, a CHAPSecret must be entered for both the remote device and for the CyberSWITCH. Refer to theSystem Information for information regarding the System Secret. If OutboundAuthentication has been disabled, a CHAP Secret is not required for the remote device.IP Routing with PPP Bridge Devices (Using BCP)To allow devices to connect to the CyberSWITCH using IP routing through a PPP Bridge device,you must configure a RLAN IP Network Interface. IP routing must also be enabled. For each PPPBridge using this type of connection, you may need to enter the Device Name, a Calling Line Id, aPAP Password or a CHAP Secret, and an IP (Sub) Network Number.Security Mode Configuration On-node Device Table ConfigurationDataCalling Line Id PAP or CHAPSecurityCalling Line Id PAP Password orCHAP SecretDisabled Enabled Not Requested RequiredEnabled Enabled Optional perdevice entryRequiredEnabled Disabled Required Optional
