Cabletron Systems CSX1200 User Manual

Also see for CyberSWITCH CSX1000: User guide Quick start

Contents

Workgroup Remote Access Switch 545S YSTEM COMMANDSLAN CommandsLAN C OMMANDSThe following commands are used to display current system LAN diagnostic information:lan statsDisplays the current LAN packet forwarding statistics, including the number of framesreceived and transmitted from LAN and WAN connections. Refer to LAN Statistics, for a list ofavailable statistics and their definitions.lan stat clearClears the current LAN packet forwarding statistics.lan testTransmits a test message onto the LAN and test for proper LAN connections. If the transmit issuccessful, the following message will be displayed:LAN port #> Transmit was successfulIf the transmit fails, refer to the section titled LAN Attachment to determine the reason for thefailure.LOG C OMMANDSThe following commands control the report logging feature for the system’s subsystems.log cdr displayDisplays the local call detail recording report log.log cdr eraseErases the local call detail recording log report.log cdr writeWrites the local CDR log to disk. The file is written to the \LOG directory. The file name is“CDR_LOG”. The file extension is .1, .2, and so on up to .10. The file extension cycles throughthe extension values with each write command, similar to the current report log file and statuslog file, so that the ten most recent versions of the CDR log are available on the system disk.P ACKET C APTURE C OMMANDSIn many applications, it is often desirable to monitor incoming LAN data. Thepkt commandswill allow you to capture, display, save, and load bridged or routed data packets.You must configure the terminal setting the same for Telnet and the terminal emulation package.To do this, use theterm set command.Note: Packet capture commands are available for both local and remote (Telnet) connections.The following diagnostic packet commands are available:pkt [on/off]Enables or disables the Packet Capture feature.