• ipv6 nd raguard policy policy-name — define the RA guard policy name and enter the RA guard policyconfiguration mode.mtuEnable the verification of the configured maximum transmission unit (MTU) value in the received RA packets.Syntax mtu valueTo reset the MTU value, use the no mtu value command.Parameters value Enter the maximum transmission unit value in bytes. The range is from 1,280 to 11,982bytes.Defaults 0Command Modes POLICY LIST CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.11(0.0) Introduced on the C9010.9.10(0.0) Introduced on the S6100-ON.9.9(0.0) Introduced on the Z9500.9.8(1.0) Introduced on the Z9100-ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000–ON.9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.Related Commands • ipv6 nd ra-guard enable — configure the RA guard related commands.• ipv6 nd raguard policy policy-name — define the RA guard policy name and enter the RA guard policyconfiguration mode.other–config–flagEnable the verification of the advertised other configuration parameter. If this command is not configured, the verification process isbypassed.Syntax other-config-flag {on | off}To reset the other configuration parameter, use the no other-config-flag {on | off} command.Parameters on Enter the keyword on to set the other-config-flag value as ON.off Enter the keyword off to set the other-config flag value as OFF.Neighbor Discovery Protocol (NDP) 1037
