Version Description7.7.1.0 Introduced on the C-Series.neighbor distribute-listDistribute BGP information via an established prefix list.Syntax neighbor {ip-address | peer-group-name} distribute-list prefix-list-name {in |out}To delete a neighbor distribution list, use the no neighbor {ip-address | peer-group-name}distribute-list prefix-list-name {in | out} command.Parameters ip-address Enter the IP address of the neighbor in dotted decimal format.peer-group-name Enter the name of the peer group to apply the distribute list filter to all routers in the peergroup.prefix-list-name Enter the name of an established prefix list.If the prefix list is not configured, the default is permit (to allow all routes).in Enter the keyword in to distribute only inbound traffic.out Enter the keyword out to distribute only outbound traffic.Defaults Not configured.Command Modes ROUTER BGPCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000–ON.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.8.1.0 Introduced on the S-Series.7.7.1.0 Introduced on the C-Series.384 Border Gateway Protocol
