ip ospf costChange the cost associated with the OSPF traffic on an interface.Syntax ip ospf cost costTo return to default value, use the no ip ospf cost command.Parameters cost Enter a number as the cost. The range is from 1 to 65535.Defaults The default cost is based on the reference bandwidth.Command Modes INTERFACECommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100-ON.9.8(1.0) Introduced on the Z9100-ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.6.1.0 Introduced on the S-Series.7.5.1.0 Introduced on the C-Series.pre- 6.1.1.1 Introduced on the E-Series.Usage Information If this command is not configured, cost is based on the auto-cost command.When you configure OSPF over multiple vendors, to ensure that all routers use the same cost, use the ip ospfcost command. Otherwise, OSPF routes improperly.Related Commands • auto-cost — control how the OSPF interface cost is calculated.Open Shortest Path First (OSPFv2 and OSPFv3) 1091
