Version Description9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.8.0 Introduced on the S4810.OSPFv3 CommandsOpen shortest path first version 3 (OSPFv3) for IPv6 is supported on the platform.The fundamental mechanisms of OSPF (flooding, DR election, area support, SPF calculations, and so on) remain unchanged. However,OSPFv3 runs on a per-link basis instead of on a per-IP-subnet basis. Most changes were necessary to handle the increased address size ofIPv6.The Dell Networking implementation of OSPFv3 is based on IETF RFC 2740.area authenticationConfigure an IPsec authentication policy for OSPFv3 packets in an OFSPFv3 area.Syntax area area-id authentication ipsec spi number {MD5 | SHA1} [key-encryption-type]keyParameters area area-id Area for which OSPFv3 traffic is to be authenticated. For area-id, you can enter a number.The range is from 0 to 4294967295.ipsec spi number Security Policy index (SPI) value that identifies an IPsec security policy.The range is from 256 to 4294967295.MD5 | SHA1 Authentication type: Message Digest 5 (MD5) or Secure Hash Algorithm 1 (SHA-1).key-encryption-type(OPTIONAL) Specifies if the key is encrypted.The values are 0 (key is not encrypted) or 7 (key is encrypted).key Text string used in authentication.1148 Open Shortest Path First (OSPFv2 and OSPFv3)
