2 00:00:00:00:00:03 Dynamic Po 100 Active2 00:00:00:00:00:04 Dynamic Po 10 ActiveUsage Information The following describes the show mac-address-table count command shown in the following example.Line BeginningWithDescriptionMAC Entries... Displays the number of MAC entries learned per VLAN.Dynamic Address... Lists the number of dynamically learned MAC addresses.Static Address... Lists the number of user-defined MAC addresses.Total MAC... Lists the total number of MAC addresses the switch uses.Example (Count) Dell# show mac-address-table countMAC Entries for all vlans :Dynamic Address Count : 110Static Address (User-defined) Count : 0Sticky Address Count : 0Total Synced Mac from Peer(N): 100Total MAC Addresses in Use: 110Dell#Related Commands • show mac-address-table aging-time — display MAC aging time.show mac-address-table aging-timeDisplay the aging times assigned to the MAC addresses on the switch.Syntax show mac-address-table aging-time [vlan vlan-id]Parameters vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to display the MAC addressassigned to the VLAN. The range is from 1 to 4094.Command Modes • EXEC• EXEC PrivilegeCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.Layer 2 931
