ip rip send versionTo send a specific version of RIP, set the interface. The version you set on the interface overrides the version command in ROUTER RIPmode.Syntax ip rip send version [1] [2]To return to the default value, use the no ip rip send version command.Parameters 1 (OPTIONAL) Enter the number 1 for RIP version 1. The default is RIP version 1.2 (OPTIONAL) Enter the number 2 for RIP version 2.Defaults RIPv1Command Modes INTERFACECommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100-ON.9.8(1.0) Introduced on the Z9100-ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.8.1.0 Introduced on the S-Series.7.6.1.0 Introduced on the C-Series.pre- 6.2.1.1 Introduced on the E-Series.Usage Information To enable the interface to send both version of RIP packets, use the ip rip send version 1 2 command.Related Commands • ip rip receive version — sets the RIP version for the interface to receive traffic.• version — sets the RIP version for the switch software.1328 Routing Information Protocol (RIP)
