Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.12.0 Introduced on the S4810.Usage Information When you enter no fefd for an interface and fefd-global, FEFD is enabled on the interface because the nofefd command is not retained in the configuration file. To keep the interface FEFD disabled when the globalconfiguration changes, use the fefd reset command.Related Commands • fefd disable — disable far-end failure detection on an interface.• fefd reset — enable FEFD globally on the system.• fefd mode — change FEFD mode on an interface.fefd disableDisable FEFD on an interface only. This command overrides the fefd reset command for the interface.Syntax fefd disableTo re-enable FEFD on an interface, use the no fefd disable command.Defaults Not configured.Command Modes INTERFACECommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.Layer 2 947
