ip igmp snooping last-member-query-intervalThe last member query interval is the maximum response time inserted into Group-Specific queries sent in response to Group-Leavemessages.Syntax ip igmp snooping last-member-query-interval millisecondsTo return to the default value, use the no ip igmp snooping last-member-query-intervalcommand.Parameters milliseconds Enter the interval in milliseconds. The range is from 100 to 65535. The default is 1000milliseconds.Defaults 1000 millisecondsCommand Modes INTERFACE VLANCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.5(0.1) Introduced on the Z9500.9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux(PMUX) mode only.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.6.1.0 Introduced on the S-Series.7.5.1.0 Introduced on the C-Series.E-Series legacycommandUsage Information This last-member-query-interval is also the interval between successive Group-Specific Query messages. Tochange the last-member-query interval, use this command.Internet Group Management Protocol (IGMP) 657