Version Description8.1.1.0 Introduced on the E-Series.7.6.1.0 Introduced on the S-Series.7.5.1.0 Introduced on the C-Series.6.2.1.0 IntroducedExample (SingleRange)This example shows the macro named test that was defined earlier.Dell(config)# interface range macro testDell(config-if-range-te-1/1/1/1-1/1/1/3,te-1/1/3/1-1/1/4/4,te-1/1/7/1-1/1/9/1)#DellRelated Commands • interface range — configure a range of command (bulk configuration).• interface range macro (define) — define a macro for an interface range (bulk configuration).interface vlanConfigure a VLAN. You can configure up to 4094 VLANs.Syntax interface vlan vlan-id [of-instance{of-id}]Parameters vlan-id Enter a number as the VLAN Identifier. The range is from 1 to 4094.of-instance{of-id} Enter the keyword of-instance then the OpenFlow instance ID to add the VLAN to thespecified OpenFlow instance. The range is from 1 to 8.NOTE: Associate the OpenFlow instance with the VLAN when the VLAN iscreated. An existing VLAN cannot be associated with an OpenFlow instance.Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.Command Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.9.1.(0.0) Introduced on the S4810; added support for OpenFlow.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.Interfaces 685
