Version Description8.3.7.0 Introduced on the S4810.7.7.1.0 Introduced on the S-Series.7.6.1.0 Introduced on the C-Series.7.4.1.0 Introduced on the E-Series.Related Commands • protocol lldp (Configuration) — enable LLDP globally.• debug lldp interface — debug LLDP.• show lldp neighbors — display the LLDP neighbors.helloConfigure the rate at which the LLDP control packets are sent to its peer.Syntax hello secondsTo revert to the default, use the no hello seconds command.Parameters seconds Enter the rate, in seconds, at which the control packets are sent to its peer. The rate isfrom 5 to 180 seconds. The default is 30 seconds.Defaults 30 secondsCommand Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.7.1.0 Introduced on the S-Series.962 Link Layer Discovery Protocol (LLDP)
