Version DescriptionE-Series legacycommandUsage Information This command enables the IGMP switch to send General Queries periodically. This behavior is useful when there isno multicast router present in the VLAN because the multicast traffic is not routed. Assign an IP address to theVLAN interface for the switch to act as a querier for this VLAN.show ip igmp snooping groupsDisplay snooping related information for all the IGMP groups, interface or one group of one interface.Syntax show ip igmp snooping groups [group-address [detail] | detail | interface[group-address [detail]]]Parameters snooping Enter the keyword snooping to display snooping related information.group-address (OPTIONAL) Enter the group address in dotted decimal format to view information onthat group only.interface (OPTIONAL) Enter the interface type and the interface information:• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet thenthe stack/slot/port/subport information.• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then thestack/slot/port/subport information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then thestack/slot/port information.• For a Loopback interface, enter the keyword loopback then a number from 0 to16383.• For a port channel interface, enter the keywords port-channel then a number.• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.detail (OPTIONAL) Enter the keyword detail to display the IGMPv3 source information.Command Modes • EXEC• EXEC PrivilegeCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.660 Internet Group Management Protocol (IGMP)
