Version Description9.8(1.0) Introduced on the Z9100-ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.5(0.1) Introduced on the Z9500.9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.8.4.2.1 Introduced on the C-Series and S-Series.8.4.2.0 Introduced on the E-Series.7.7.1.0 Introduced on the E-Series.Related Commands • ip redirect-list – enable an IP Redirect List.ip redirect-groupApply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an interface by entering this commandmultiple times.Syntax ip redirect-group redirect-list-name test [l2–switch]To remove a redirect list from an interface, use the no ip redirect-group name command.Parameters redirect-list-name Enter the name of a configured redirect list.l2–switch Enter the keyword l2–switch to enable PBR on Layer2 (switched) traffic.Defaults NoneCommand Modes INTERFACE (conf-if-vl-)Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.11(2.0P1) Introduced the l2–switch attribute.9.10(0.0) Introduced on the S6100-ON.9.8(1.0) Introduced on the Z9100-ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.1188 Policy-based Routing (PBR)
