Version Description7.6.1.0 Introduced on the C-Series.7.4.1.0 Introduced on the E-Series.modeTo receive or transmit, set LLDP.Syntax mode {tx | rx}To return to the default, use the no mode command.Parameters tx Enter the keyword tx to set the mode to transmit.rx Enter the keyword rx to set the mode to receive.Defaults Both transmit and receive.Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.7.1.0 Introduced on the S-Series.7.6.1.0 Introduced on the C-Series.7.4.1.0 Introduced on the E-Series.Related Commands • protocol lldp (Configuration) — enable LLDP globally.• show lldp neighbors — display the LLDP neighbors.Link Layer Discovery Protocol (LLDP) 963
