Version Description8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the S4810.8.1.1.0 Introduced on the E-Series.7.5.1.0 Introduced on the C-Series.pre-6.1.1.0 Introduced on the E-Series.Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocolroute) is preferred over the Management Static route. Also, Management static routes and the ManagementConnected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4and IPv6 management routes. This command manages both tables.Related Commands • interface ManagementEthernet — configure the Management port on the system (either the Primary orStandby RPM).• speed (Management interface) — set the speed for the Management interface.show arpDisplay the ARP table.Syntax show arp [vrf vrf-name] [interface interface | ip ip-address [mask] |macaddress mac-address [mac-address mask]] [retries] [static | dynamic][inspection {database | statistics][summary]Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF.NOTE: Use this attribute to start a BGP instance for either a specific addressfamily corresponding to the default VRF or an IPv4 address familycorresponding to a non-default VRF.interface interface (OPTIONAL) Enter the following keywords and the interface information:• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet thenthe stack/slot/port/subport information.• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then thestack/slot/port/subport information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then thestack/slot/port information.• For the Management interface on the stack-unit, enter the keywordManagementEthernet then the slot/port information.• For a port channel interface, enter the keywords port-channel then a number.784 IPv4 Routing
