To enable the Resilient Ring Protocol, use the no disable command.Defaults DisabledCommand Modes CONFIGURATION (conf-frrp)Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000–ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.8.2.1.0 Introduced on the C-Series.7.4.1.0 Introduced.interfaceConfigure the primary, secondary, and control-vlan interfaces.Syntax interface {primary interface secondary interface control-vlan vlan-id}To return to the default, use the no interface {primary interface secondary interfacecontrol-vlan vlan-id} command.Parameters primary interface Enter the keyword primary to configure the primary interface then one of the followinginterfaces and the interface information:• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet thenthe stack/slot/port/subport information.• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then thestack/slot/port/subport information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.614 Force10 Resilient Ring Protocol (FRRP)
