Object TrackingObject Tracking supports IPv4 and IPv6, and is available on the Dell Networking platforms.Object tracking allows you to define objects of interest, monitor their state, and report to a client when a change in an object’s stateoccurs. The following tracked objects are supported:• Link status of Layer 2 interfaces• Routing status of Layer 3 interfaces (IPv4 and IPv6)• Reachability of IPv4 and IPv6 routes• Metric thresholds of IPv4 and IPv6 routesYou can configure client applications, such virtual router redundancy protocol (VRRP), to receive a notification when the state of a trackedobject changes.Topics:• IPv4 Object Tracking Commands• IPv6 Object Tracking CommandsIPv4 Object Tracking CommandsThe following section describes the IPv4 VRRP commands.debug trackEnables debugging for tracked objects.Syntax debug track [all | notifications | object-id]Parameters all Enables debugging on the state and notifications of all tracked objects.notifications Enables debugging on the notifications of all tracked objects.object-id Enables debugging on the state and notifications of the specified tracked object. Therange is 1 to 500.Defaults Enable debugging on the state and notifications of all tracked objects (debug track all).Command Modes • EXEC• EXEC PrivilegeCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.351046 Object Tracking
