Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100-ON.9.8(1.0) Introduced on the Z9100-ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.8.1.0 Introduced to all platforms.7.6.1.0 Introduced on the S-Series.7.5.1.0 Introduced on the C-Series.pre- 6.1.1.1 Introduced on the E-Series.Usage Information To enable OSPF on an interface, the network area command must include, in its range of addresses, theprimary IP address of an interface.NOTE: An interface can be attached only to a single OSPF area.If you delete all the network area commands for Area 0, the show ip ospf command output does not list Area0.passive-interfaceSuppress both receiving and sending routing updates on an interface.Syntax passive-interface {default | interface}To enable both the receiving and sending routing, use the no passive-interface interface command.To return all OSPF interfaces (current and future) to active, use the no passive-interface defaultcommand.Parameters default Enter the keyword default to make all OSPF interfaces (current and future) passive.interface Enter the following keywords and slot/port or number information:Open Shortest Path First (OSPFv2 and OSPFv3) 1103
