show config (from INTERFACE RANGE mode)Display the bulk configured interfaces (interface range).Syntax show configCommand Modes CONFIGURATION INTERFACE (conf-if-range)Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.8.1.1.0 Introduced on the E-Series.7.6.1.0 Introduced on the S-Series.7.5.1.0 Introduced on the C-Series.6.1.1.0 Introduced on the E-Series.Example Dell(conf)# interface range tengigabitethernet 1/1/1/1 - 1/1/1/2Dell(conf-if-range-te-1/1/1-1/1/1/2)# show config!interface TenGigabitEthernet 1/1/1/1no ip addressswitchportno shutdown!interface TenGigabitEthernet 1/1/1/2no ip addressswitchportno shutdownshow interfacesDisplay information on a specific physical interface or virtual interface.Syntax show interfaces interface-type[—range]Interfaces 699
