rate-interval (Configuration Mode)Configure the traffic sampling interval for all physical and logical port-channel interfaces globally. The support to configure rate-intervalglobally enables you to modify the default interval rate for all physical and logical interfaces at one time.Syntax rate-interval secondsUse the no rate-interval command to remove the sampling interval configuration.Parameters seconds Enter the number of seconds for which to collect traffic data. The range is from 5 to 299seconds.NOTE: Because polling occurs every 15 seconds, the number of secondsdesignated here round to the multiple of 15 seconds lower than the enteredvalue. For example, if 44 seconds is designated, it rounds to 30; 45 to 59seconds rounds to 45. If you configure this value to be less than 5, then theentire buffer is cleared; the show int stats command shows the rateinformation to be 0 as the polling interval is less than 5.Defaults 299 secondsCommand Modes CONFIGURATIONCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.11.0.0 Introduced on all Dell Networking OS platforms.Usage Information The output of the show interfaces command displays the configured rate interval, along with the collectedtraffic data.When rate-interval is not configured in the global configuration mode or interface mode, the default value of 299seconds is applied.When rate-interval is configured only in the global configuration mode and not in the interface mode, the globalrate-interval value is applied at the interface level also.When rate-interval is configured at the interface level and not in the global configuration mode, the interface levelrate-interval value is applied for an interface.When rate interval is configured in both global configuration mode as well as interface mode, then the rate-intervalvalue configured at interface level is applied as it takes precedence over the global value.show configDisplay the interface configuration.Syntax show configCommand Modes INTERFACEInterfaces 697
