interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes atwhich ACL logs must be generated. The time interval range is from 1 to 10 minutes.Defaults By default, 10 ACL logs are generated if you do not specify the threshold explicitly.The default frequency at which ACL logs are generated is five minutes.Command Modes CONFIGURATION-EXTENDED-ACCESS-LISTCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.3(0.0) Added support for logging of ACLs on the S4810, S4820T, and Z9000 platforms.Usage Information When the configured maximum threshold is exceeded, generation of logs is stopped. When the interval at whichACL logs are configured to be recorded expires, the subsequent, fresh interval timer is started and the packetcount for that new interval commences from zero. If ACL logging was stopped previously because the configuredthreshold is exceeded, it is re-enabled for this new interval.If ACL logging is stopped because the configured threshold is exceeded, it is re-enabled after the logging intervalperiod elapses. ACL logging is supported for standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. Youcan configure ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable logging for ACLsthat are associated with egress interfaces.Related Commands • deny — assign a filter to deny IP traffic.• deny tcp — assign a filter to deny TCP traffic.deny (for IPv6 ACLs)Configure a filter that drops IPv6 packets that match the filter criteria.Syntax deny {ipv6-protocol-number | icmp | ipv6 | tcp | udp} [count [byte]] [dscpvalue] [order] [fragments] [log [interval minutes] [threshold-in-msgs [count]][monitor] [no-drop]To remove this filter, you have two choices:• Use the no seq sequence-number command syntax if you know the filter’s sequence number• Use the no deny {ipv6-protocol-number | icmp | ipv6 | tcp | udp} commandParameters log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.threshold-in msgscount(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicatethe maximum number of ACL logs that can be generated, exceeding which the generationof ACL logs is terminated. with the seq, permit, or deny commands. The thresholdrange is from 1 to 100.330 Access Control Lists (ACL)
