Version Description7.8.1.0 Introduced on the S-Series.7.6.1.0 Introduced on the C-Series.pre- 6.2.1.1 Introduced on the E-Series.Usage Information This command is intended for low-speed interfaces.passive-interfaceSuppress routing updates on a specified interface.Syntax passive-interface interfaceTo delete a passive interface, use the no passive-interface interface command.Parameters interface Enter the following information:• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet thenthe stack/slot/port/subport information.• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then thestack/slot/port/subport information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then thestack/slot/port information.• For a Port Channel interface, enter the keywords port-channel then a number.• For a VLAN, enter the keyword vlan then a number from 1 to 4094.Defaults Not configured.Command Modes ROUTER RIPCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100-ON.9.8(1.0) Introduced on the Z9100-ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.Routing Information Protocol (RIP) 1335
