Parameters interface (OPTIONAL) Enter the following keywords and the interface information:• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet thenthe stack/slot/port/subport information.• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then thestack/slot/port/subport information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then thestack/slot/port information.• For a VLAN interface, enter the keyword vlan, and then the VLAN ID. The VLAN IDrange is from 1 to 4094.priority-cost (OPTIONAL) Enter a number as the amount to subtract from the priority value. The rangeis from 1 to 254. The default is 10.Defaults priority cost = 10Command Modes VRRPCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.0.2.0 Introduced on the S6000.7.6.1.0 Introduced on the S-Series (S50 only).7.5.1.0 Introduced on the C-Series.6.2.1.1 Introduced on the E-Series.Usage Information If you disable the interface, the cost value is subtracted from the priority value and forces a new MASTER electionif the priority value is lower than the priority value in the BACKUP virtual routers.virtual-addressConfigure up to 12 virtual router IP addresses in the VRRP group. To start sending VRRP packets, set at least one virtual IP address for theVRRP group.Syntax virtual-address ip-address1 [... ip-address12]1720 Virtual Router Redundancy Protocol (VRRP)
