show ip igmp groupsView the IGMP groups.Syntax show ip igmp [vrf vrf-name] groups [group-address [detail] | detail | interface[group-address [detail]]]Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure thissetting on that VRF.group-address (OPTIONAL) Enter the group address in dotted decimal format to view information onthat group only.interface (OPTIONAL) Enter the interface type and the interface information:• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet thenthe stack/slot/port/subport information.• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then thestack/slot/port/subport information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then thestack/slot/port information.• For a Loopback interface, enter the keyword loopback then a number from 0 to16383.• For a port channel interface, enter the keywords port-channel then a number.• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.detail (OPTIONAL) Enter the keyword detail to display the IGMPv3 source information.Command Modes • EXEC• EXEC PrivilegeCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Added support for VRF. Introduced on the S6000-ON.9.5(0.1) Introduced on the Z9500.Internet Group Management Protocol (IGMP) 647
