Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000–ON.9.2(1.0) Introduced on the Z9500.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.6.1.0 Introduced on the S-Series.7.5.1.0 Introduced on the C-Series.6.2.1.1 Introduced on the E-Series.Usage Information This command applies to dynamic port-channel interfaces only. When applied on a static port-channel, thiscommand has no effect.Related Commands • show lacp — display the LACP configuration.lacp port-priorityTo influence which ports will be put in Standby mode when there is a hardware limitation that prevents all compatible ports fromaggregating, configure the port priority.Syntax lacp port-priority priority-valueTo return to the default setting, use the no lacp port-priority priority-value command.Parameters priority-value Enter the port-priority value. The higher the value number, the lower the priority. Therange is from 1 to 65535. The default is 32768.Defaults 32768Command Modes INTERFACECommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.914 Link Aggregation Control Protocol (LACP)
