To delete a setting, enter no set metric.Parameters + (OPTIONAL) Enter + to add a metric-value to the redistributed routes.- (OPTIONAL) Enter - to subtract a metric-value from the redistributed routes.metric-value Enter a number as the new metric value. The range is from zero (0) to 4294967295.Defaults Not configured.Command Modes ROUTE-MAPCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100-ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000–ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.8.1.1.0 Introduced on the E-Series.7.6.1.0 Introduced on the S-Series.7.5.1.0 Introduced on the C-Series.pre-6.1.1.0 Introduced on the E-Series.Related Commands • set automatic-tag — compute the tag value of the route.• set level — specify the OSPF area for route redistribution.• set metric-type — specify the route type assigned to redistributed routes.• set tag — specify the tag assigned to redistributed routes.set metric-typeTo assign a new route type for routes redistributed to OSPF, configure a filter.Syntax set metric-type {internal | external | type-1 | type-2}To delete a setting, use the no set metric-type command.280 Access Control Lists (ACL)
