implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action of theACL from implicit-deny to implicit-permit (that is, if the traffic does not match the filtersin the ACL, the traffic is permitted instead of dropped).vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The range isfrom 1 to 4094 (you can use IDs from 1 to 4094).optimized (OPTIONAL) Enter the keyword optimized to enable ACL optimization.Defaults Not enabled.Command Modes INTERFACECommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command-Line Reference Guide.Version Description9.11(0.0) Introduced on the S4048–ON, S4048T–ON, S6000, S6000–ON, S6010–ON, S6100–ON,Z9100–ON, and Z9500.Related Commands • ip access-list standard — configure a standard ACL.• ip access-list extended — configure an extended ACL.ip control-plane egress-filterEnable egress Layer 3 ACL lookup for IPv4 CPU traffic.Syntax ip control-plane egress-filterDefaults Not enabled.Command Modes EXEC PrivilegeCommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100-ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000–ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.188 Access Control Lists (ACL)
