Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.5(0.1) Introduced on the Z9500.9.3(0.0) Introduced on the S6000, S4810, S4820T, Z9000.Usage Information This command is only valid for tunnel interfaces with an IPv6 outer header.tunnel hop-limitConfigure the method to set the IPv4 time-to-live or the IPv6 hop limit value in the outer tunnel header.Syntax tunnel hop-limit valueTo restore the default tunnel hop-limit, use the no tunnel hop-limit command.Parameters value Enter the hop limit (ipv6) or time-to-live (ipv4) value to include in the tunnel header. Therange is from 0 to 255. The default is 64.Defaults 64 (Time-to-live for IPv4 outer tunnel header or hop limit for IPv6 outer tunnel header)Command Modes INTERFACE TUNNEL (conf-if-tu)Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100–ON.9.8(1.0) Introduced on the Z9100–ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.5(0.1) Introduced on the Z9500.9.3(0.0) Introduced on the S6000, S4810, S4820T, Z9000.Usage Information A value of 0 copies the inner packet hop limit (ipv6) or time-to-live (ipv4) in the encapsulated packet to the tunnelheader hop limit (ipv6) or time-to-live (ipv4) value.Tunneling 1633
