ip rip receive versionTo receive specific versions of RIP, set the interface. The RIP version you set on the interface overrides the version command in ROUTERRIP mode.Syntax ip rip receive version [1] [2]To return to the default, use the no ip rip receive version command.Parameters 1 (OPTIONAL) Enter the number 1 for RIP version 1.2 (OPTIONAL) Enter the number 2 for RIP version 2.Defaults RIPv1 and RIPv2Command Modes INTERFACECommand History This guide is platform-specific. For command information about other platforms, see the relevant Dell NetworkingOS Command Line Reference Guide.Version Description9.10(0.0) Introduced on the S6100-ON.9.8(1.0) Introduced on the Z9100-ON.9.8(0.0P5) Introduced on the S4048-ON.9.8(0.0P2) Introduced on the S3048-ON.9.7(0.0) Introduced on the S6000-ON.9.2(1.0) Introduced on the Z9500.9.0.2.0 Introduced on the S6000.8.3.19.0 Introduced on the S4820T.8.3.11.1 Introduced on the Z9000.8.3.7.0 Introduced on the S4810.7.8.1.0 Introduced on the S-Series.7.6.1.0 Introduced on the C-Series.pre- 6.2.1.1 Introduced on the E-Series.Usage Information If you want the interface to receive both versions of RIP, use the ip rip receive version 1 2 command.Related Commands • ip rip send version — sets the RIP version for sending RIP traffic on an interface.• version — sets the RIP version the switch software uses.Routing Information Protocol (RIP) 1327
