NXP Semiconductors QorIQ LS1012A Reference Manual

FTMx_SWOCTRL field descriptions (continued)Field Description0 The channel output is not affected by software output control.1 The channel output is affected by software output control.30CH1OCChannel 1 Software Output Control Enable0 The channel output is not affected by software output control.1 The channel output is affected by software output control.31CH0OCChannel 0 Software Output Control Enable0 The channel output is not affected by software output control.1 The channel output is affected by software output control.19.4.27 FTM PWM Load (FTMx_PWMLOAD)Enables the loading of the MOD, CNTIN, C(n)V, and C(n+1)V registers with the valuesof their write buffers when the FTM counter changes from the MOD register value to itsnext value or when a channel (j) match occurs. A match occurs for the channel (j) whenFTM counter = C(j)V.Address: Base address + 98h offsetBit 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15R 0WReset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0Bit 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31R 0LDOK 0CH7SELCH6SELCH5SELCH4SELCH3SELCH2SELCH1SELCH0SELWReset 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0FTMx_PWMLOAD field descriptionsField Description0–21ReservedThis field is reserved.This read-only field is reserved and always has the value 0.22LDOKLoad EnableEnables the loading of the MOD, CNTIN, and CV registers with the values of their write buffers.0 Loading updated values is disabled.1 Loading updated values is enabled.Table continues on the next page...Chapter 19 FlexTimer Module (FTM)QorIQ LS1012A Reference Manual, Rev. 1, 01/2018NXP Semiconductors 907