line Enter a text string for your MOTD banner the message with yourdelineator. The delineator is a percent character (%).Defaults No banner is configured.Command Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.E-Series Original commandUsageInformationA MOTD banner message is displayed only in EXEC Privilege mode after entering the enablecommand followed by the password. These banners are not displayed to users in EXEC (non-privilege) mode.RelatedCommandsbanner exec – enables the display of a text string when you enter EXEC mode.banner login – sets a banner to be displayed after successful login to the system.cam-audit linecardEnable audit of the IPv4 forwarding table on all line cards.E-SeriesSyntax cam-audit linecard all ipv4-fib interval time-in-minutesParameters all Enter the keyword all to enable CAM audit on all line cards.ipv4-fib Enter the keyword ipv4-fib to designate the CAM audit on theIPv4 forwarding entries.intervaltime-in-minutesEnter the keyword interval followed by the frequency in minutesof the CAM audit. Range: 5 to 1440 minutes (24 hours). Default: 60minutes.Defaults DisabledCommand Modes CONFIGURATIONCommand History Version 7.4.1.0 Introduced on the E-Series.UsageInformationEnables periodic audits of the software and hardware copies of the IPv4 forwarding table.101
