match external {1| 2}(OPTIONAL) Enter the keywords match external to redistributeOSPF external routes. You can specify 1 or 2 to redistribute thoseroutes only.match internal (OPTIONAL) Enter the keywords match internal to redistributeOSPF internal routes only.route-mapmap-name(OPTIONAL) Enter the keywords route-map followed by the nameof a configured route map.Defaults Not configured.Command Modes ROUTER BGPCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.3.1.0 Introduced the ability to substitute IGP cost for MED when a peer/peer-group outbound route-map is set as internal.Version 7.8.1.0 Introduced on the S-Series.Version 7.7.1.0 Introduced on the C-Series.UsageInformationWith FTOS version 8.3.1.0 and later, you can use the redistribute command to advertisethe IGP cost as the MED on redistributed routes. When you set the route-map with metric-typeinternal and apply outbound to an EBGP peer/peer-group, the advertised routes correspondingto those peer/peer-group have the IGP cost set as MED.When you enter the redistribute isis process-id command without any otherparameters, FTOS redistributes all OSPF internal routes, external type 1 routes, and externaltype 2 routes. This feature is not supported by an RFC.router bgpEnter ROUTER BGP mode to configure and enable BGP.C-Series, E-Series, S-Series, Z-Series, S4810Syntax router bgp as-numberTo disable BGP, use the no router bgp as-number command.Parametersas-number Enter the AS number. The range is 1 to 65535 (2-byte), 1 to 4294967295(4-byte), or 0.1 to 65535.65535 (dotted format).Defaults Not enabled.Command Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.385
