excludesourceaddress(OPTIONAL) Enter the keyword exclude followed by the sourceaddress, in dotted decimal format (A.B.C.D), for which a static entryneeds to be added.includesourceaddress(OPTIONAL) Enter the keyword include followed by the sourceaddress, in dotted decimal format (A.B.C.D), for which a static entryneeds to be added.Defaults noneCommand Modes INTERFACECommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.Version 7.7.1.0 Introduced on the C-Series.Version 7.5.1.0 Expanded to support the exclude and include options.E-Series legacycommandUsageInformationA group in include mode must have at least one source address defined. In excludemode, if you do not specify a source address, FTOS implicitly assumes all sources are included.If you do not specify either include or exclude, FTOS implicitly assumes a IGMPv2 staticjoin.Command Limitations• Only one mode (include or exclude) is permitted per multicast group perinterface. To configure another mode, all sources belonging to the original mode mustbe unconfigured.• If a static configuration is present and a packet for the same group arrives on aninterface, the dynamic entry completely overwrites all the static configuration for thegroup.RelatedCommandsshow ip igmp groups – displays IGMP group information.ip igmp versionManually set the version of the router to IGMPv2 or IGMPv3.C-Series, E-Series, S-Series, Z-Series, S4810Syntax ip igmp version {2 | 3}Parameters 2 Enter the number 2 to set the IGMP version number to IGMPv2.675
