ip rip send versionSet the interface to send a specific version of RIP. The version you set on the interface overrides the version commandin ROUTER RIP mode.C-Series, E-Series, S-Series, Z-Series, S4810Syntax ip rip send version [1] [2]To return to the default value, use the no ip rip send version command.Parameters 1 (OPTIONAL) Enter the number 1 for RIP version 1. The default isRIPv1.2 (OPTIONAL) Enter the number 2 for RIP version 2.Defaults RIPv1Command Modes INTERFACECommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the S-Series.Version 7.6.1.0 Introduced on the C-Series.pre-Version6.2.1.1Introduced on the E-Series.UsageInformationTo enable the interface to send both version of RIP packets, use the ip rip sendversion 1 2 command.RelatedCommandsip rip receive version – sets the RIP version for the interface to receive traffic.version – sets the RIP version to be used for the switch software.ip split-horizonEnable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents anyroutes learned over a specific interface to be sent back out that interface.C-Series, E-Series, S-Series, Z-Series, S4810Syntax ip split-horizonTo disable split-horizon, use the no ip split-horizon command.Defaults EnabledCommand Modes INTERFACE1244
