Defaults 8Command Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.E-Series legacycommandsnmp-server trap-sourceConfigure a specific interface as the source for SNMP traffic.C-Series, E-Series, S-Series, Z-SeriesSyntax snmp-server trap-source interfaceTo disable sending traps out a specific interface, use the no snmp trap-sourcecommand.Parametersinterface Enter the following keywords and slot/port or number information:• For an 100/1000 Ethernet interface, enter the keywordGigabitEthernet followed by the slot/port information.• For a 1-Gigabit Ethernet interface, enter the keywordGigabitEthernet followed by the slot/port information.• For a Loopback interface, enter the keyword loopbackfollowed by a number from 0 to 16383.• For a SONET interface, enter the keyword sonet followed bythe slot/port information.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet followed by the slot/portinformation.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE followed by the slot/port information.• For VLAN interface, enter the keyword vlan followed by anumber from 1 to 4094.Defaults The IP address assigned to the management interface is the default.Command Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.Version 7.6.1.0 Introduced on the S-Series.1375
