Use this parameter only with a password that you copied from theshow running-config file of another Dell Force10 router.password Enter a text string, up to 32 characters long, as the clear textpassword.Defaults No password is configured.level = 15.Command Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.0Introduced on the E-Series.UsageInformationUse this command to define a password for a level and use the privilege level(CONFIGURATION mode) command to control access to command modes.Passwords must meet the following criteria:• Start with a letter, not a number.• Passwords can have a regular expression as the password. To create a password witha regular expression in it, you must use CNTL + v prior to entering regular expression.For example, to create the password abcd]e, you type “abcd CNTL v ]e”. Whenthe password is created, you do not use the CNTL + v key combination and enter“abcd]e”.NOTE: The question mark (?) and the tilde (~) are not supported characters.RelatedCommandsshow running-config – views the current configuration.privilege level (CONFIGURATION mode) – controls access to the command modes within theswitch.enable restrictedAllows Dell Force10 technical support to access restricted commands.C-Series, E-Series, S-Series, Z-Series, S4810Syntax enable restricted [encryption-type] passwordTo disallow access to restricted commands, use the no enable restricted command.Parametersencryption-type (OPTIONAL) Enter the number 7 as the encryption type.Enter 7 followed a text string as the hidden password. The text stringmust be a password that was already encrypted by a Dell Force10router.1297
