To return to the default values, use the no max-age command.Parametersmax-age Enter a number of seconds the FTOS waits before refreshingconfiguration information. The range is 6 to 40. The default is 20seconds.Defaults 20 secondsCommand Modes MULTIPLE SPANNING TREECommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.Version 6.5.1.0 Introduced.RelatedCommandsforward-delay – the amount of time the interface waits in the Blocking State and the LearningState before transitioning to the Forwarding State.hello-time – changes the time interval between BPDUs.max-hopsConfigure the maximum hop count.C-Series, E-Series, S-Series, Z-SeriesSyntax max-hops numberTo return to the default values, use the no max-hops command.Parameters range Enter a number for the maximum hop count. The range is 1 to 40. Thedefault is 20.Defaults 20 hopsCommand Modes MULTIPLE SPANNING TREECommand History Version 8.3.11.1 Introduced on the Z9000.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.Version 6.5.1.0 Introduced.UsageInformationThe max-hops command is a configuration command that applies to both the IST and all MSTinstances in the MSTP region. The BPDUs sent out by the root switch set the remaining-hops995
