Series, the range is 1 to 128. For the E-Series, the range is 1 to255 for Tera Scale.• For SONET interfaces, enter the keyword sonet followed bythe slot/port information. This keyword is only available onthe E-Series and C-Series.• For a 10–Gigabit Ethernet interface, enter the keywordTenGigabitEthernet followed by the slot/portinformation.Defaults Disabled.Command Modes EXEC PrivilegeCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.E-Series legacycommandUsageInformationIGMP commands acceptonly non-VLAN interfaces—specifying VLAN does not yield results.This command displays packets for IGMP and IGMP snooping.ip igmp access-groupUse this feature to specify access control for packets.C-Series, E-Series, S-Series, Z-Series, S4810Syntax ip igmp access-group access-listTo remove the feature, use the no ip igmp access-group access-list command.Parametersaccess-list Enter the name of the extended ACL (16 characters maximum).Defaults Not configuredCommand Modes INTERFACE (conf-if-interface-slot/port)Command History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Introduced on the C-Series and S-Series.Version 7.6.1.0 Introduced on E-Series.669
