ip msdp sa-filterPermit or deny MSDP source active (SA) messages based on multicast source and/or group from the specified peer.E-Series, Z-Series, S4810Syntax ip msdp sa-filter {in | out} peer-address list [access-listname]Remove this configuration using the no ip msdp sa-filter {in | out} peeraddress list [access-list name] command.Parameters in Enter the keyword in to enable incoming SA filtering.out Enter the keyword out to enable outgoing SA filtering.peer-address Enter the peer address of the MSDP peer in a dotted decimal format(A.B.C.D.).access-list name Enter the name of an extended ACL that contains permitted SAs. Ifyou do not use this option, all local entries are blocked.Defaults Not configured.Command Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.7.1.0 Introduced on the E-Series.ip msdp sa-limitConfigure the upper limit of source-active (SA) entries in SA-cache.E-Series, Z-Series, S4810Syntax ip msdp sa-limit numberTo return to the default, use the no ip msdp sa-limit number command.Parametersnumber Enter the maximum number of SA entries in SA-cache. The range is 0to 40000.Defaults 50000Command Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.985
