To delete a filter, use the no distribute-list prefix-list-name in[interface] command.Parametersprefix-list-name Enter the name of a configured prefix list.interface (OPTIONAL) Enter one of the following keywords and slot/port ornumber information:• For a 1-Gigabit Ethernet interface, enter the keywordGigabitEthernet followed by the slot/port information.• For Port Channel groups, enter the keywords port-channel followed by a number. For the C-Series and S-Series, the range is 1 to 128. For the E-Series, the range is 1 to32 for EtherScale and 1 to 255 for TeraScale.• For a SONET interface, enter the keyword sonet followed bythe slot/port information.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet followed by the slot/portinformation.• For a VLAN, enter the keyword vlan followed by a numberfrom 1 to 4094.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE followed by the slot/port information.Defaults Not configured.Command Modes ROUTER OSPFCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.8.1.0 Added support for the Multi-Process OSPF.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.1Introduced on the E-Series.distribute-list outApply a filter to restrict certain routes destined for the local routing table after the SPF calculation.C-Series, E-Series, S-Series, Z-Series, S4810Syntax distribute-list prefix-list-name out [bgp | connected | isis |rip | static]To remove a filter, use the no distribute-list prefix-list-name out [bgp| connected | isis | rip | static] command.Parametersprefix-list-name Enter the name of a configured prefix list.1049
