SFP 1 Temperature Low Alarm Flag = FalseSFP 1 Voltage Low Alarm Flag = FalseSFP 1 Tx Bias Low Alarm Flag = FalseSFP 1 Tx Power Low Alarm Flag = FalseSFP 1 Rx Power Low Alarm Flag = True===================================!-------output truncated -------------------------!RelatedCommandsinterface – configures a physical interface on the switch.show ip interface – displays Layer 3 information about the interfaces.show interfaces – displays information on a specific physical interface or virtual interface.show inventory (C-Series and E-Series) – displays the chassis type, components (includingmedia), FTOS version including hardware identification numbers and configured protocols.show inventory (S-Series) – displays the S-Series switch type, components (including media),FTOS version including hardware identification numbers and configured protocols.show rangeDisplay all interfaces configured using the interface range command.C-Series, E-Series, S-Series, Z-SeriesSyntax show rangeCommand Modes INTERFACE RANGE (config-if-range)Command History Version 8.3.11.1 Introduced on the Z9000.Version 8.2.1.0 Added support for 4093 VLANs on E-Series ExaScale.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.Version 6.1.1.0 Introduced.Example FTOS(conf-if-range-so-2/0-1,fa-0/0)#show rangeinterface sonet 2/0 - 1interface fastethernet 0/0FTOS(conf-if-range-so-2/0-1,fa-0/0)#RelatedCommandsinterface – configures a physical interface on the switch.show ip interface – displays Layer 3 information about the interfaces.show interfaces – displays information on a specific physical interface or virtual interface.745
