show protocol-termination-tableDisplay the IP packet termination table (IPPTT).E-SeriesSyntax show protocol-termination-table linecard number port-set port-pipe-numberParameters linecardnumber Enter the keyword linecard followed by slot number of the linecard. For the E-Series, the range is 0 to 13 on a E1200/1200i, 0 to 6 on aE600/E600i, and 0 to 5 on a E300.port-setport-pipe-numberEnter the keywords port-set followed by the line card’s Port-Pipenumber. The range is 0 to 1.Defaults noneCommand Modes • EXEC• EXEC PrivilegeCommand History Version 8.1.1.2 Introduced on the E-Series ExaScale E600i.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 6.4.1.0 IntroducedUsageInformationThe IPPTT table is used for looking up forwarding information for IP control traffic destined tothe router. For the listed control traffic types, IPPTT contains the information for the following:• Which CPU to send the traffic (CP, RP1, or RP2)• What QoS parameters to setExample FTOS#show protocol-termination-table linecard 2 port-set 0Index Protocol Src-Port Dst-Port Queue DP Blk-Hole VlanCPUEgPort--------------------------------- -- -------- --------------0 ICMP any any Q0 0 No - CP1 UDP any 1812 Q7 6 No - CP2 UDP any 68 Q7 6 No - CP3 UDP any 67 Q7 6 No - CP4 TCP any 22 Q7 6 No - CP5 TCP 22 any Q7 6 No - CP6 TCP 639 any Q7 6 No - RP27 TCP any 639 Q7 6 No - RP28 TCP 646 any Q7 6 No - RP19 TCP any 646 Q7 6 No - RP110 UDP 646 any Q7 6 No - RP111 UDP any 646 Q7 6 No - RP112 TCP 23 any Q7 6 No - CP13 TCP any 23 Q7 6 No - CP14 UDP any 123 Q7 6 No - CP15 TCP any 21 Q7 6 No - CP16 TCP any 20 Q7 6 No - CP830
