RelatedCommandsinterface – configures a physical interface on the switch.show ip interface – displays Layer 3 information about the interfaces.show interfaces – displays information on a specific physical interface or virtual interface.show interfaces transceiver – displays the physical status and operational status of aninstalled transceiver. The output also displays the transceiver’s serial number.show interfaces transceiverDisplay the physical status and operational status of an installed transceiver. The output also displays the transceiver’sserial number.C-Series, E-Series, S-Series, Z-SeriesSyntax show interfaces [gigabitethernet slot/port | tengigabitethernetslot/port | fortyGigE slot/port] transceiverParameters gigabitethernet For a 10/100/1000 interface, enter the keyword gigabitethernetfollowed by the slot/port information.tengigabitethernetFor a 10G interface, enter the keyword tengigabitethernetfollowed by the slot/port information.fortyGigE For a 40G interface, enter the keyword fortyGigE followed by theslot/port information.Command Modes • EXEC• EXEC PrivilegeCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.8.1.0 Output augmented with diagnostic data for pluggable media.Version 7.7.1.0 Removed three fields in the output: Vendor Name, Vendor OUI, andVendor PN.Version 7.6.1.0 Introduced on the C-Series and S-Series.Version 6.5.4.0 Introduced on the E-Series.UsageInformationThe following describes the show interfaces transceiver command shown in theExample below.740
