storm-control unknown-unicast (Interface)Configure percentage of unknown-unicast traffic allowed on an interface (ingress only).C-Series, E-Series, S-Series, Z-Series, S4810Syntax storm-control unknown-unicast [percentage decimal_value in] |[wred-profile name]] [packets_per_second in]To disable unknown-unicast storm control on the interface, use the no storm-controlunknown-unicast [percentage decimal_value in] | [wred-profilename]] [packets_per_second in] command.Parameterspercentagedecimal_value [in| out]E-Series Only: Enter the percentage of broadcast traffic allowed in orout of the network. Optionally, you can designate a decimal valuepercentage, for example, 55.5%.Percentage: 0 to 100:• 0% blocks all related traffic.• 100% allows all traffic into the interface.The decimal range is .1 to .9.wred-profilenameE-Series Only: (Optionally) Enter the keywords wred-profilefollowed by the profile name to designate a wred-profile.packets_per_second inC-Series and S-Series Only: Enter the packets per second ofbroadcast traffic allowed into the network. The range is 0 to 33554431.Defaults noneCommand Modes INTERFACE (conf-if-interface-slot/port)Command History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.Version 7.4.1.0 E-Series Only: Added the percentage decimal value option.Version 6.5.1.0 Introduced on the E-Series.1409
