Defaults Not configured.Command Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.0Introduced for the E-Series.ip max-frag-countSet the maximum number of fragments allowed in one packet for packet re-assembly.C-Series, E-Series, S-Series, Z-Series, S4810Syntax ip max-frag-count countTo place no limit on the number of fragments allowed, use the no ip max-frag-countcommand.Parameterscount Enter a number for the number of fragments allowed for re-assembly.The range is 2 to 256.Defaults No limit is set on number of fragments allowed.Command Modes CONFIGURATIONCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 8.1.1.0 Introduced on the E-Series ExaScale.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.0Introduced for the E-Series.UsageInformationTo avoid denial of service (DOS) attacks, keep the number of fragments allowed for re-assembly low.790
