Gi 0/9 Down Auto Auto --Gi 0/10 Down Auto Auto --Gi 0/11 Down Auto Auto --Gi 0/12 Down Auto Auto --Gi 0/13 Down Auto Auto --Gi 0/14 Down Auto Auto --Gi 0/15 Down Auto Auto -FTOS#RelatedCommandsshow interfaces – displays information on a specific physical interface or virtual interface.show interfaces switchportDisplay only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE802.1Q tag status and VLAN membership.C-Series, E-Series, S-Series, Z-SeriesSyntax show interfaces switchport [interface [linecard slot-number] |stack-unit unit-id ]Parametersinterface (OPTIONAL) Enter one of the following keywords and slot/port ornumber information:• For a 1-Gigabit Ethernet interface, enter the keywordGigabitEthernet followed by the slot/port information.• For a Port Channel interface, enter the keywords port-channel followed by a number. For the C-Series and S-Series, the range is 1 to 128. For the E-Series, the range is 1 to255 for TeraScale and 1 to 512 for ExaScale.• For SONET interfaces, enter the keyword sonet followed bythe slot/port information. This keyword is only available on E-Series and C-Series.• For a 10-Gigabit Ethernet interface, enter the keywordTenGigabitEthernet followed by the slot/portinformation.• For a 40-Gigabit Ethernet interface, enter the keywordfortyGigE followed by the slot/port information.• Enter the keyword backup to view the backup interface forthis interface.linecardslot-number(OPTIONAL) Enter the keyword linecard followed by the slotnumber. For the C-Series, the range is 0 to 7 for C300 and 0 to 3 forC150. For the E-Series, the range is 0 to 13 on the E1200, 0 to 6 on theE600, and 0 to 5 on the E300stack-unitunit-id (OPTIONAL) Enter the keywords stack-unit followed by the stackmember number. This option is available only on S-Series. The rangeis 0 to 1.738
