If the switch attempts to contact a DHCP server and one is not found, it enters a loop whilereloading in BMP mode. Enter the stop bmp command to interrupt the reload and boot up inNormal mode. The startup configuration is then loaded from the local flash on the switch.Use the reload-type command in BMP 3.0 to toggle between Normal and BMPAutoConfiguration modes. The reload settings for AutoConfiguration mode that you configureare stored in memory and retained for future reboots and BMP software upgrades. You canenter the reload command at any time to reload the switch in the last configured mode:Normal reload or BMP mode.RelatedCommands • show reload-type — displays the current reload mode (Normal or BMP mode).• stop bmp – stops the BMP process and prevents a loop if the DHCP server is not found.script post-configRun this command to execute the post-configuration script after applying the start up configuration,Z-Series, S4810Syntax script post-config {script-name}Parameter post-configscriptnameEnter the name of the script to be run after the BMP start-upconfiguration has been applied.Defaults NoneCommand Modes CONFIGURATIONCommand History Version 9.1(0.0) Introduced on Z9000 and S4810.UsageInformationIf a pre-configuration script for BMP 3.0 is executed and if the post configuration script ispresent in the start-up configuration, the post-configuration script will be executed.RelatedCommandsshow reload-typeDisplay the reload type currently configured on the system.Z-Series, S4810Syntax show reload-typeDefaults none543
