50System Time and DateThe commands in this chapter configure time values on the system, either using the Dell Force10 operating software(FTOS), or the hardware, or using the network time protocol (NTP). With NTP, the switch can act only as a client to anNTP clock host.For more information, refer to the “Network Time Protocol” section of theManagement chapter in theFTOSConfiguration Guide.The commands in this chapter are generally supported on the C-Series, E-Series, Z-Series, and S-Series, with someexceptions, as notes in the Command History fields.calendar setSet the time and date for the switch hardware clock.C-Series, E-Series, S-Series, Z-Series, S4810Syntax calendar set time month day yearParameterstime Enter the time in hours:minutes:seconds. For the hour variable, usethe 24-hour format; for example, 17:15:00 is 5:15 pm.month Enter the name of one of the 12 months in English. You can enter thename of a day to change the order of the display to time day monthyear.day Enter the number of the day. The range is 1 to 31. You can enter thename of a month to change the order of the display to time day monthyear.year Enter a four-digit number as the year. The range is 1993 to 2035.Command Modes EXEC PrivilegeCommand History Version 8.3.11.1 Introduced on the Z9000.Version 8.3.7.0 Introduced on the S4810.Version 7.6.1.0 Introduced on the S-Series.Version 7.5.1.0 Introduced on the C-Series.pre-Version6.1.1.0Introduced on the E-Series.1425
