FTOS(conf)#int te 0/5FTOS(conf-if-te-0/5)#no shutFTOS(conf-if-te-0/5)#FTOS(conf-if-te-0/5)#FTOS(conf-if-te-0/5)#FTOS(conf-if-te-0/5)#ipv6 nd prefix FEC0::/10FTOS(conf-if-te-0/5)#FTOS(conf-if-te-0/5)#show conf!interface TenGigabitEthernet 0/5ip address 78.21.1.3/24ipv6 nd prefix fec0::/10flowcontrol rx on tx onno shutdownFTOS(conf-if-te-0/5)#FTOS#upgrade (C-Series version)Upgrade the bootflash or boot selector image on a processor.C-SeriesSyntax upgrade {bootflash-image | bootselector-image | system-image}{all | linecard {number | all} | rpm} [booted | file-url |repair]Parameters bootflash-image Enter the keyword bootflash-image to upgrade the bootflashimage.bootselector-imageEnter the keyword bootselector-image to upgrade the bootselector image. Use with TAC supervision only.system-image Enter the keyword system-image to upgrade the system image.Use with TAC supervision only.all • Enter the keyword all to upgrade the bootflash or bootselector image on all processors. This keyword does notupgrade the bootflash on the standby RPM.• Enter the keyword all after the keyword linecard toupgrade the bootflash or boot selector image on all linecards.linecardnumber Enter the keyword linecard followed by the line card slot number.Range: 0 to 7 for the C300 and 0 to 2 for the C150.rpm Enter the keyword rpm to upgrade the system image of a selectorimage on all processors on the RPM.repair Enter this keyword repair to upgrade a line card newly insertedinto an already upgraded chassis. This option is only available withthe system-image keyword.87
